!!!ATTENTION!!!*Dish Network®, (DISH) is NOT affiliated with this website.*!!!ATTENTION!!!
Satellite-TV-Planet.com
Satellite-TV-Planet.com
 
 
 
 



Sponsored Links




 

 
 

!!!ATTENTION!!!*Dish Network (DISH) is not affiliated with this website.*!!!ATTENTION!!!

Dish Key Codes

 
 

Programming Device Codes: Cable Box Device Codes

Dish Networks universal remote control will operate up to 4 devices. You can program your dish network universal remote control to operate in VCR Mode - VCRs, AUX Mode - Amplifier /Receivers, TV Mode - Televisions, and SAT Mode - Satellite receiver Devices. To program your dish network universal remote control you will need the correct remote codes that link your remote control signal with the desired devices. Before you enter a code into the universal remoter control device you will need to prep it.

Remote Codes

Follow these steps and enter the corresponding code:

Have your Dish Network Universal Remote Control in hand.

* Remote automatically times out if no buttons are pressed within 20 seconds. To retry or start over simply allow the remote control to idol for 20 seconds.

Choose one of the 4 device modes VCR/DVD Mode, SAT Mode, TV Mode, or AUX Mode. Press and hold the button for 3 seconds or until all the mode keys are light up.

With the numbered buttons enter the code that corresponds to your equipment you are linking with the Dish Networks universal remote control. A light should flash on and off for each number pressed. After the full code is entered press the (#) button. If you have entered the code correctly the mode light will flash 3 times. Repeat theses steps if you have on seen this confirmation signal.


Program Your Dish Network Remote Control is 6 Easy Steps

Cable Box Device Codes

GI/Tocom 0140
Hamlin 0147, 0148
Jerrold 0135, 0136, 0137, 0149
Oak 0146
Panasonic 0144, 0145
Pioneer 0142, 0143
Regal 0147
Scientific Atlanta 0138, 0139, 0150
Zenith 0141
 



Sponsored Links